<menu id="w22om"><s id="w22om"></s></menu>
  • <dd id="w22om"><u id="w22om"></u></dd>
    <strong id="w22om"><strong id="w22om"></strong></strong><label id="w22om"><blockquote id="w22om"></blockquote></label>
    <dd id="w22om"></dd>
    歡迎訪問山東燊赫通風設備有限公司網站!

    服務熱線
    0531--68856675
    網站首頁
    公司簡介
    產品中心
    工程案例
    新聞中心
    留言反饋
    聯系我們
    咨詢熱線 0531--68856675

    新聞中心

    當前位置: 首頁-新聞中心 > 解決廚房排煙設備發熱嚴重的問題
    解決廚房排煙設備發熱嚴重的問題
    來源:http://www.xs38u.cn/ 發布時間:2022/06/05

    如今市場提高了餐飲業的環保要求,特別是餐飲業廚房要求非常干凈整潔。為了減少廚房油煙造成的污染,餐館酒店紛紛安裝廚房排煙設備。但是,廚房排煙設備在長時間工作時會出各種故障,例如:廚房排煙設備發熱嚴重,那么,如何解決廚房排煙設備發熱嚴重的問題。
    Now the market has raised the environmental requirements of the catering industry, especially the kitchen of the catering industry is required to be very clean and tidy. In order to reduce the pollution caused by kitchen oil smoke, restaurants and hotels have installed kitchen smoke exhaust equipment. However, when the kitchen smoke exhaust equipment works for a long time, there will be various failures. For example, the kitchen smoke exhaust equipment is seriously heated. How to solve the problem of serious heating of the kitchen smoke exhaust equipment.
    濟南廚房排煙設備加熱嚴重:定子繞組局部短路,油軸承嚴重缺油。及時清洗保養可以恢復凈化效果。廚房排煙設備鑰匙開關不工作。電機扭矩減小,速度變慢,所以要更換同規格的電容。
    Serious heating of kitchen smoke exhaust equipment: partial short circuit of stator winding and serious oil shortage of oil bearing. Timely cleaning and maintenance can restore the purification effect. The key switch of kitchen smoke exhaust equipment does not work. The motor torque decreases and the speed slows down, so it is necessary to replace the capacitor with the same specification.
    濟南廚房排煙
    應修復或更換短路的繞組,廚房餐廳廚房排煙設備加熱溶液潤滑不良:應適當涂油。如果軸承損壞,應更換軸承。每個檔位鑰匙開關都可以鎖定。機械性能好,但電機不能啟動。檢查各檔位開關的公共連接是否斷開,并修理開路。
    The short-circuit winding shall be repaired or replaced. The heating solution of the kitchen exhaust equipment in the kitchen, dining room and kitchen is not well lubricated: it shall be properly oiled. If the bearing is damaged, replace the bearing. Each gear key switch can be locked. Good mechanical performance, but the motor cannot be started. Check whether the common connection of each gear switch is disconnected and repair the open circuit.
    如果其中一個齒輪按電機不能運轉,另一個正常,檢查是否有接觸損壞或連接收縮;按下開關電機運行,釋放時無法鎖定。
    If one of the gears fails to operate according to the motor and the other is normal, check whether there is contact damage or connection shrinkage; Press the switch and the motor runs. It cannot be locked when it is released.
    檢查無法鎖定的開關導電彈簧是否與導電膜接觸,或者開關彈簧片是否脫落移位。彈簧應進行調整或更換;兩個檔位應該同時鎖定。應檢查聯鎖彈簧的位移和變形。如果要調整和修理聯鎖彈簧,則應進行調整和修理。
    Check whether the switch conductive spring that cannot be locked is in contact with the conductive film, or whether the switch spring sheet falls off and shifts. The spring shall be adjusted or replaced; Both gears should be locked at the same time. The displacement and deformation of the interlock spring shall be checked. If the interlock spring is to be adjusted and repaired, it shall be adjusted and repaired.
    以上就是廚房排煙設備發熱時的解決方法,如果大家還有什么想了解的,可以繼續關注我們網站www.xs38u.cn的動態更新。
    The above is the solution to the heating of kitchen smoke exhaust equipment. If you want to know more, you can continue to follow our website www.jnqsg Com.

    上一篇:食堂油煙機排煙罩的特征及制作要求 下一篇:油煙凈化器正確的電源連接要求

    新聞推薦

    通風管道的加工要多注意安全事項2022-07-27
    考驗廚房排煙設備核心質量的三大維度2022-07-25
    更換油煙凈化器在從廠家訂購前注意五點2022-07-23
    通風管道加工安裝的六大注意事項2022-07-21
    廚房排煙沒起作用可以這樣處理2022-07-20
    油煙凈化器有些部件是可以拆換的2022-07-19
    影響廚房排煙吸油效果的因素有哪些?2022-07-18
    油煙凈化器凈化效果以及使用常識2022-07-18
    返回列表
    網站首頁 公司簡介 產品中心 工程案例 新聞中心 留言反饋 聯系我們
    contact us聯系我們
    地址:濟南市天橋區
    電話:0531--68856675
    QR code關注我們
    二維碼拿出手機掃一掃